HL hydrophobic paints
Material HL is based on thermoplastic polymers such as polyethylene, epoxy, polyurethane, etc. combined in various percentages. It does not contain any toxic substances.
Material HL hardens in contact with air. The hardening rate is dependent on ambient air temperature and humidity. After hardening the material is absolutely harmless, so that it can be used as coating of concrete reservoirs for potable water storage. It is also suitable for inside protection of concrete sewerage.
On Customer’s request, the material can be made in any colour.
Service temperature: -40°C to 90°C.
Density: 1.1 to 1.2 g/cm³.
Resistant to sea water and Dead sea water salts.
Chemical Stability
1. Material HL is highly resistant to moisture and aqueous solutions of non-organic salts. The maximum moisture absorption is 0.02% after an unlimited time in water.
2. Material HL is resistant to:
36% hydrochloric acid (HCl) solution;
50% phosphoric acid (H3PO4) solution;
10% sulphuric acid (H2SO4) solution;
5% solutions of acetic, citric, formic, maleic and oxalic acids;
alkalis of any concentration at temperatures of up to 50°C.
3. Material HL is not resistant to:
sodium fluoride;
calcium hypochloride;
titanium tetrachloride;
selenyl chloride;
aldehydes, esters, ketones, chlorinated, aliphatic and aromatic hydrocarbons;
benzene, xylene.
Material Application
Material HL should be applied to the surface to be protected as a thin layer by using a brush, a roller, an air sprayer, or by airless deposition.
Since material HL is produced as a concentrate, it can be diluted to the necessary concentration by using a thinner. With special requirements for waterproofing, two layers are to be applied.
For questions, email us at info@halik.biz , or visit the Contact Page. all rights reserved to HALIK LTD
